EZ-Clone Low Pro 64 Site Cutting System, Black

High-Density Aeroponic Propagation, 64-Site Low Pro System (Black)

Rooting cuttings by hand in trays or rockwool cubes works at small volume, but it gets inconsistent fast once a grower needs to keep dozens of clones on the same schedule. The EZ-Clone Low Pro 64-Site Cutting System runs on aeroponic misting rather than soaked media, suspending cuttings over a fine mist so roots develop faster and more uniformly across the whole tray.

This Black 64-site unit is built from UV-protected HDPE in EZ-Clone's reduced-height Low Pro profile, with a reinforced lid and reservoir sized to match its site count. It ships with a MAG 750 pump rated at 700 GPH, ready to load cuttings once collars are added.

Key Features & Benefits

• Alpha-numeric ID markings — printed on the lid so growers running multiple strains or mother plants can track individual cuttings by position.
• Finger slots for collar access — let growers pull and reseat collars without disturbing neighboring cuttings.
• UV-protected HDPE construction — resists UV degradation and holds up to repeated cycles of misting, draining, and cleaning.
• MAG 750 pump included — rated at 700 GPH, sized to maintain even misting pressure across all 64 sites.
• Recessed, protected drain — keeps drainage contained and reduces the chance of spills when emptying the reservoir.
• Leak-resistant cord outlet — routes the pump cord through a sealed opening that accepts multiple cords without leaking.
• Fully recyclable HDPE body — built with more than 75 design changes over earlier EZ-Clone generations, aimed at durability and easier cleaning.

Who Should Use This System

The 64-site Low Pro fits growers who need to root 64 cuttings on a consistent schedule, whether that's a home grower maintaining a handful of mother plants or a commercial operation running dedicated propagation rooms.

About EZ-Clone

EZ-Clone Enterprises is a Sacramento, California-based propagation equipment manufacturer that originated the aeroponic plant cloning system format in 2000. The Low Pro line is its current flagship, assembled in the USA and sold across 16, 32, 64, and 128-site configurations.

Frequently Asked Questions

How many cuttings can the 64-site system hold?

This system holds up to 64 individual cuttings at once, one per collar site in the lid. Each site mists independently, so all 64 cuttings receive the same aeroponic root-zone conditions.

How does aeroponic cloning differ from rooting in trays or cubes?

Aeroponic systems suspend the cut stem over a fine mist instead of packing it into a soaked medium, which keeps oxygen available at the root zone throughout the rooting process. That tends to produce more consistent root development across a full tray than tray-and-dome propagation.

When should I transplant cuttings out of the system?

Most growers transplant once visible root development is 1 to 2 inches long, which typically takes one to two weeks depending on strain and cutting quality. Pulling cuttings too early risks transplant shock before roots are established enough to support the plant on their own.

What pump does the 64-site system use?

It ships with a MAG 750 pump rated at 700 GPH, sized to maintain consistent mist pressure across all 64 sites in the reservoir. The pump is also sold separately as a replacement part if it ever needs swapping.

Is this system compatible with EZ-Clone collars and accessories?

Yes, the Low Pro line uses EZ-Clone's standard collar sizing, so both soft and hard cloning collars fit the lid's sites. Replacement misters and other EZ-Clone accessories are also cross-compatible across the Low Pro range.

How do I clean the system between cycles?

Drain the reservoir fully, then rinse the lid, collars, and reservoir with a mild cleaning solution before starting a new batch of cuttings. Regular cleaning between cycles reduces the risk of algae or pathogen buildup in the misting chamber.