Bluelab Intelligent EC Probe with 5m Cable for IntelliDose

Restore Accurate Nutrient Readings to Your IntelliDose, 5 m Cable

The IntelliDose doses nutrients based on its conductivity reading, so a failing EC probe means every dose is off. This Intelligent EC Probe is a direct replacement for the IntelliDose's EC probe. It measures conductivity and temperature reliably so dosing stays on target.

The 5 m / 16 ft cable reaches from a wall-mounted controller to a sample pot or reservoir in commercial layouts.

Key Features & Benefits

• Direct replacement — for the EC probe on the Bluelab IntelliDose Controller (BCTIND01).
• Multiple units — measures EC, CF, TDS and ppm 700, plus temperature in °C and °F.
• 5 m / 16 ft cable — reaches sample pots and reservoirs.
• Simple wiring — black, white and red wire configuration.

Who Should Use the Intelligent EC Probe

IntelliDose Controller owners replacing a damaged or worn conductivity probe.

About Bluelab Intelligent EC Probe

Bluelab supplies the Intelligent EC Probe as the replacement conductivity sensor for the IntelliDose Controller (BCTIND01).

Frequently Asked Questions

Which controller does this probe fit?

It is a direct replacement for the EC probe on the Bluelab IntelliDose Controller (BCTIND01).

What does it measure?

It measures conductivity in EC, CF, TDS and ppm 700, and temperature in °C and °F.

How is it wired?

The wire configuration is black, white and red. Follow the IntelliDose manual when connecting it.

Why does EC accuracy matter for dosing?

The IntelliDose adds nutrients until the solution reaches its EC target. If the probe reads wrong, the controller will over- or underdose.